Instructions

1. Run the drain pipes through the floor and attach to the plumbing.
2. Rough-in the water supply and drain lines to the fittings to ensure proper fit before assembly, and make adjustments if needed.
3. Install the Faucet.
4. Note: We recommend using the SinkSense® rough-in kit model # SDT901-PCV.
5. Set the Bathtub on its side.
6. Position the Bottom Drain Pipe and hold it in place for the next step.
7. Attach the Drain Gasket and the Drain Mechanism to the Bottom Drain Pipe.
8. Place the Bathtub upright in its final location.
9. Attach the Pipe Extension to the Drain Pipe. Connect the Pipe Bezel to the Pipe Extension.
10. Position the Overflow Pipe and hold it in place for the next step.
11. Attach the Overflow Cap to the Overflow Pipe using the Overflow Cap Screw.
12. Remove the Pipe Nut and Compression Washer from the bottom of the Tee Connector.
13. Attach the Pipe Nut and Compression Washer to the Pipe Extension.
14. Remove the Pipe Nut and Compression Washer from the Tee Connector and slide them onto the Overflow Pipe.
15. Attach the Tee Connector to the Overflow Pipe and secure the Tee with the Pipe Nut.
16. Remove the Pipe Nut and Compression Washer from the Tee Connector.
17. Place the Pipe Nut and Compression Washer to the Bottom Drain Pipe.
18. Secure the Tee Connector to the Bottom Drain Pipe and tighten the Pipe Nut.
19. Secure the Tee Connector to the Pipe Extension with the Pipe Nut.
20. Turn on the water, check for leaks, and repair if needed.
21. If you wish to seal the Bathtub to the floor, we recommend using 100% Neutral-Cure Silicone Sealant.
22. Note: Allow the Sealant time to cure properly before using the Bathtub.

Congratulations, this completes the installation of the Sinkology Freestanding Bath Tub.